Xpres Cut Plus: Ultragraphics Roland CX-24 system Manual - Manual (Page 8)

6
Using the Roland CX-24
The Opus eye on the Roland CX-24 needs to be turned on before you use it to cut full colour
images using the Ultragraphics process. Refer to page 5 for button positions, and page 7 for
media sizes.
1. Turn the cutter on, you will see SELECT | ROLL on the display
2. Press the MENU button on the display
3. Rotate the BLUE jog wheel clockwise until you see CROPMARK | on the display
4. Press the MENU button until the cursor is flashing on
5. Rotate the BLUE jog wheel clockwise until you see on the display
6. Press the ENTER key. You will now see CROPMARK | on the display
7. Rotate the BLUE jog wheel anticlockwise until you see SELECT | ROLL on the display
Loading the material into the cutter
1. Ensure the material clamping lever is in the down position
2. Load material from the rear of the machine making sure the
two bottom cropmarks on the paper are lined up with the grey
grey cutting strip. Pull the above lever up to lock material in position.
Grey Cutting Strip
3. Press the ENTER key on the panel. The cutter will now read all three cropmarks. When
finished the head will rest on the bottom left corner of the material. DO NOT press ORIGIN
Cropmarks