Xpres Subli-Print Epson R1800: Feeder System Troubleshooting Guide - Manual (Page 8)

Page | 8
Remove the backing tape from the tube
support (2b) and fit it to the printer housing as
shown.
Place the small tube clamp on the printer
housing on the left as shown and clamp the
tubes in place.
Plug the printer back into the mains supply
and the print head will move back and forth
then perform its initial ink charge.
The air you may see in the tubes is not
significant and will not affect the operation of
the system in any way.
Your system is ready to go…..