Xpres Subli-Print Epson R1800: Feeder System Troubleshooting Guide - Manual (Page 7)

Page | 7
Move the print head back to its cartridge
removal position.
Fit cartridges into their respective slots and
firmly press them down into place.
The tube support (2a) fits on the printer
housing 70mm (2¾”) from the edge of the
bridge as shown.
Remove the backing tape and firmly press the
tube support into position.
With the print head pushed to its furthest
position on the right, take up any slack in the
tubing by pulling it through the tube clamp.