Xpres Subli-Print Epson R1800: Feeder System Troubleshooting Guide - Manual (Page 16)

Page | 16
4. Use the syringe and needle provided. Push the needle through the hole (you will feel it
slide through a rubber grommet).
5. Draw the syringe back so that only ink (no air bubbles) is being pulled into the syringe.
If you are using the Easy Flow III system then you will need to re-prime the cartridges in the
following way.
6. Using a syringe, insert it into the bung in the bottom of the cartridge as shown in the
picture below. It may be a tight fit for the syringe but it will fit with a little pressure and
care.
7. Prime the cart by drawing the ink into the syringe