Xpres Subli-Print Epson R1800: Feeder System Troubleshooting Guide - Manual (Page 3)

Page | 3
Troubleshooting Guide
In order to setup your Continuous Ink Supply System on you Epson R1800 you will need to
follow the instructions carefully.
1. The first step in order to setup your CISS is to follow the ‘Installation instructions for the
Epson R1800 Easy Flow IV’ (see Appendix A).
2. If you have followed the installation instructions carefully and you find that you cannot
print out a perfect nozzle check then please follow the ‘How to Get a Good Nozzle
Check’ instructions carefully (see Appendix B).
3. If still you cannot get a nozzle check follow the ‘Bad Nozzle Check Flow Chart’ (see
Appendix C).
4. If you have followed the ‘Bad Nozzle Check Flow Chart’ instructions without success
then you will need to make sure that the flow of the ink isn’t obscured in anyway. In
order to do this please follow the ‘How to Prime the Ink Cartridges and Check the Flow
of Ink’ instructions (see Appendix F).
Operating conditions are recommended to be within temperature range of 50 – 80 °F
or 10 - 30°C.