Xpres 3D SMARTone - Manual (Page 7)

3D SMARTone INSTALLATION AND OPERATION
7
5. The Control Panel and powering on
•
Flick the red power switch to start the SMARTone
•
The SMARTone will now begin a ‘warming up’ cycle to bring the drawer and jig up to operating temperature.
•
Initial warm‐up will take around 15 minutes.
•
The SMARTone will not run a decoration cycle unless it is at operating condition.
•
Once at operating condition the SMARTone will maintain this so that it is ready to use, even if you leave it idling for an extended
period of time.
To ensure that the press is always ready keep the drawer closed when not in use.