Xpres 3D SMARTone - Manual (Page 15)

3D S SMARTone INSTALLATION N AND OPERATI ON
U
F
P
F
P
e
T
L
T
P
F
N
e
M
A
c
Use the ‘multi‐p
Fold the clear co
Pull up fully to l
Film guides are
Put a sheet of A
edge.
The film should
Load plain A4 pa
This is used to c
Pull out cassette
Fully extend the
NB: ensure that
extended.
Make a nozzle c
1) Turn o
2) Hold d
the po
A test pattern w
cassette).
purpose’ tray at
over forward.
ock in place.
self‐centering .
A5 in tray and p
be flat and not
aper into the fr
check the printi
e, load paper a
e output tray to
t the print tray
check to ensure
off printer (if tu
down the colou
ower button.
will be printed (
t the rear.
.
ush guides unt
t bowed by the
ront cassette.
ng
nd return casse
o catch printed
will not get kno
e ink is loaded c
urned on)
ur nozzle clean
using plain pap
il just touching
guides.
ette.
film.
ocked when
correctly:
button and pre
per from the fro
15
each
ess
ont