Workrite Sierra HXL Assembly Instructions for 3-Leg Front-Crank Workcenters - Manual (Page 3)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 3 of 10
Workrite Sierra HXL™ 3-Leg Crank Workcenters - Assembly Instructions
Right Leg
Left Leg
Center Leg
Verify that you have all the hardware and tools needed for the assembly (cont.)
Placement of the legs is very important. Take the time now to lay out the Legs(A), (N) & (P), Top
Leg Brackets(D), (O) & (R), Crank Tubes (T), and Brackets (B), (C) & (R) on the floor in the proper
location.
Note: the right leg will be on your left and vice versa when the assembly is seen from the back.
Attach Top Leg Brackets to all legs
If you have purchased the HX Spacer Accessory Kit, refer to instructions provided with that
product. Otherwise, proceed to step a .
Note: Right and Left Legs are interchangeable. These instructions assume you’ll use the leg from
the main carton as the Right Leg, and the leg from the Second Leg carton as the Left Leg. The
Center Leg, Center Leg Top Bracket and Center Foot must be used in the center.
Attach Top Leg Brackets (D) & (O) to Side Legs (A) & (N) using M6 × 12 mm Pan Head Screws (I)
with Allen wrench (H).
Attach Center Top Leg Bracket (R) to Center Leg (P) using Flat Pan Head Screws (L) with Allen
wrench (H).
Left Leg Right Leg Center Leg
part# 6195026-01 part# 6195026-01 part# 6195026-03
D O
H
A N
P
I I I
T
A
C
C
P
U
U
R
B Q
S
B
O
D
N
Ч2
Ч2
R
a a
b
b
b
1
2
a
b