Welch Allyn Roll Stand Kit for 1500 Patient Monitor - Installation Guide - Manual (Page 2)

Attaching Utility Basket to Roll Stand Post
1. Install Basket Clips by inserting at an angle in center of basket and rotating each Clip until horizontal (below left). Slide
both Clips to top of Basket as shown (below right).
2. Slide Clips over bottom end of Post and move Basket to upper section of Post shown below. Installation Note: Basket
must be rotated to opposite side of Post when second section is reached as shown below left.
3. Slide Clips to top and bottom of Basket as shown below right. Using a Phillips screwdriver, tighten both Clips to secure
Basket on Post. Clip hardware (2) 8-32 x 1-1/2'' PHMS and (2) 8-32 Hex Nuts has been pre-installed.
Slide Lower Clip to
bottom of Basket
DU-WA-0014-60 Rev A 4/27/10 GCX Corp. Page 2 of 5