Welch Allyn Connex and Acuity Network Installation Best Practices , User Manual - Installation Guide - Manual (Page 17)

Best practices Acuity 13
SSID/WLAN settings
Security:
•
Layer 2 Security = WPA+WPA2
WPA+WPA2 Parameters:
•
WPA Policy = Disabled
• WPA2 Policy = Enabled
• WPA2 Encryption = AES
• Auth Key Mgmt = PSK
Quality of Service (QOS)
•
Platinum (voice)
Wireless Multimedia (WMM):
•
WMM Policy = Required
• 7920 AP CAC = Disabled
• 7920 Client CAC = Disabled
Advanced:
•
Allow AAA Override = Disabled
• Coverage Hole Detection = Enabled
• Enable Session Timeout = Disabled
• Aironet IE = Disabled
• Diagnostic Channel = Disabled
• Override Interface ACL
IPv4 = None
IPv6 = None
• P2P Blocking Action = Disabled
• Client Exclusion = Disabled
• Maximum Allowed Clients = 0
• Static IP Tunneling = Disabled
• Wi-Fi Direct Clients Policy = Disabled
• Maximum Allowed Clients per AP Radio = 200
• Passive Client = Disabled
• Client Profiling = Disabled
• Media Session Snooping = Disabled
Off Channel Scanning Defer:
•
Scan Defer Priority = Enable only 6 and 7
• Scan Defer Time (msecs) = 2000
DHCP:
•
DHCP Server (Override) = Disabled
• DHCP Addr. Assignment (Required) = Disabled
Management Frame Protection (MFP) = Disabled
DTIM Period (in beacon intervals):
•
802.11a/n (1-255) = 10
• NAC = Disabled
Load Balancing and Band Select:
•
Client Load Balancing = Disabled
• Client Band Select = Disabled
Wireless Loss of connection and data.
VoIP traffic Limit VoIP traffic on 802.11a to no more than three
open connections per AP. Wireless Having more than three connections per AP has the
potential to increase patient data loss.
Best practice Affected types Without best practice