Welch Allyn CP Series Electrocardiographs - User Manual - Manual (Page 19)

Update Through Software Version 2.5 17
Symbols
CP100, CP200
Operation Symbols
General Warnings
CP100, CP200
Warnings related to Using the Electrocardiograph
General Cautions
CP100, CP200
CP100 and CP200 Directions for Use Chapter 5 updates
The following pages replace the applicable Chapter 5 pages in the previous versions of
the CP 100 and CP 200 Directions For Use.
CP 100 12-Lead Resting Electrocardiograph Directions for Use (mat. 708794)
CP 200 12-Lead Resting Electrocardiograph Directions for Use (mat. 708793)
5134 Electrostatic sensitive devices
To indicate packages containing electrostatic sensitive devices, or to identify
a device or connector that has not been tested for immunity to electrostatic
discharge.
NOTE: For further information, see IEC 60747-1.
WARNING To avoid the risk of associating ECG reports with the wrong patients,
each report must identify the patient. If any ECG report does not identify the
patient, write the patient identification information on the report immediately
following the ECG test.
Caution The Electrostatic sensitive devices symbol marked on the device
indicates devices or connectors that are sensitive to electrostatic discharge
which may result in an interruption of normal operation or damage to the device.
Prior to connecting or disconnecting accessories from the device, touch the
Equipotential stud located on the back of the device for 2 seconds or more to
remove static electricity from your body.