Welch Allyn 6V Power Supply, Rectal Light Handle - User Manual - Manual (Page 8)

1-5
To assemble/disassemble the Rectal Light Handle System:
1. Select the appropriate device from the table on page 1-6.
2. Insert the 73211 Rectal Light Handle over the devices rectangular “input
port” while twisting the 73211’s knob in the “release” direction as shown.
Release the knob and verify that the 73211 Rectal Light Handle is securely
attached to the device.
3. Plug the REF 73305, 73322, 73324, or 73326 Power Supply into an
appropriate outlet.
4. Align the plug at the end of the Rectal Light Handle cord to the connector at
the end of the Power Supply and connect. The lamp in the 73211 will turn on
immediately.
5. To turn the lamp off, disconnect the Rectal Light Handle from the Power
Supply.
6. To remove the device the from the Rectal Light Handle, twist the 73211’s
knob in the “release” direction and pull the 73211 off of the device’s input
port.
Input Port
73211