Vinten Radamec Fusion APS - Manual (Page 15)

13
Configuration
Adding Additional Landmark Maps
Additional landmark maps can be scanned and stored in the APS
scanner. This is useful if the APS pedestal is used in several different
studios. Any additional landmark maps are stored as different layers in
the memory of the APS scanner and can be recalled at any time. The
APS scanner can store up to 320 layers.
Creating a New Layer
1. On the landmark mapping page, change the Layer from the
default value of 0 to a number between 1 and 319.
2. Follow the procedure described in the section Landmark Map
Scanning on page 11 to scan and store a new landmark map to
the new layer number.
3. The LCD display also
indicates the new layer
number and number of
landmarks (targets) currently
detected.
Managing Layers
To change between stored layers:
1. Click to select the Positioning link from any page in the APS user
interface.
2. On the positioning page change the Current Layer field number to
the layer required and click Save.
Replacing a Landmark Map
The currently selected landmark map can be completely replaced. This
can be particularly useful if many of the installed reflective targets in the
studio have been moved.
1. On the scanner mode page, click the Standby Mode button and
then click to select the Landmark Mapping link.
2. On the landmark mapping page select Replace in current layer.
3. Check that Negative Mapping is not selected.
4. Click the Map Landmarks button. The APS scanner unit will
create a new landmark map using all the available reflective
targets.
5. Click the Save Landmark Map button to overwrite all previous
mapping data stored on the selected layer.
X: 1040.5
Y: 1720.4
Q: -10.265
Mode: Nav
layer
dev
lmark
: 1
: 3
: 4