Vintage Cellars 4200VSI 220V CellarPro - Manual (Page 11)

11
 Mount the unit in the upright position close to the ceiling inside the
cellar. As warm air rises to the top of the cellar, the cooling unit pulls the warm
air through the evaporator coil and removes the heat from the warm air. Once
cooled, the cold air is discharged from the front of the cooling unit and
circulates through the cellar.
 Slide the unit through from the outside of the cellar.
CAUTION : Two
people are required to move the cooling unit, which is very heavy. Do
not place the cooling unit on unprotected bottle racks.
 Tilt the cooling unit slightly backwards. The rear of the cooling unit
should be slightly lower than the front of the cooling unit to facilitate the flow of
excess condensate to the drain line.
 Use our adjustable mounting brackets to support and anchor the cooling
unit to the framing in the wall. Use the (16) #10x1-1/2” flat Phillips head wood
screws provided to anchor the screws into the studs and braces. The mounting
brackets can be used either inside or outside the cellar and can be used in three
different locations, as shown below.