Vintage Cellars Extreme ti Series - Manual (Page 9)

www.whisperkool.com | Page 7
Receiving and Inspecting the Unit
• Lift only at the designated hand hold locations on the shipping container or fully support the unit from un-
derneath. A shipment may include one or more boxes containing accessories.
• Before opening the container, inspect the packaging for any obvious signs of damage or mishandling.
• Write any discrepancy or visual damage on the Bill of Lading before signing.
• Place the box containing the WhisperKOOL unit on a tabletop to prepare it for testing prior to installing.
• Sit upright for 24 hours.
Note: WhisperKOOL Extreme units are manufactured in the USA and tested prior to shipment.
Review the Packing Slip to Verify Contents
• Check the model number to ensure it is correct.
• Check that all factory options ordered are listed.
If any items listed on the packing slip do not match your order information,
contact WhisperKOOL Customer Service immediately.
Check the Box for the following contents:
Extreme Cooling Unit
Single Piece Mounting Bracket
Accessory Kit One:
• WhisperKOOL Extreme Series Owner’s Manual
Accessory Kit Two:
• 8’ Power Cord
• Mounting Bracket Insulation Foam Short (2)
• Mounting Bracket Insulation Foam Long (2)
• Bottle Temperature Probe (Standard Unit)
Accessory Kit Three:
• 1 3/4 Standard Screws ( 9 )
• 1/2 Self-Tapping Screws (5)
• 1/2 x 1/2 Barbx MNPT Fitting
• Drain Line tube (1)
• Connection “T” (1)
RECEIVING & INSPECTING THE UNIT
Please leave the WhisperKOOL unit in its original box until you are ready for installation. This will allow you to move
the product safely without damaging it. When you are ready to remove the product from the box, refer to the installa-
tion instructions.
TIP: Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.