Torbal BAS Series - Manual (Page 11)

- 10 -
The wireless remote control allows controlling the scale and receiving the weighing result on the remote’s
LCD display in real time.
Key Primary Function
MENU Allows accessing the remote control main menu.
↑
,
↓
,
→
,
←
Allows navigating remote’s main menu.
ENTER
→
T
←
Tares the scale or accepts selected options in the main
menu.
→
0
←
Zeros the scale.
B/G
Indicates the gross weight
PRINT
Initializes the scale to print or perform data transfer
through RS232
ON/OFF Disables and enables the remote control
HR Indicates weighing result with higher resolution
BACKLIGHT Enables remote LCD backlight
1. After unpacking the remote control install four AAA batteries. To do
so unlock the remote’s access cover by moving the securities switch to
the right (1). After moving the security switch, open the battery cover
by lifting it on its left side (2). When installing the batteries be sure to
use correct polarity (+/-) (3).
To begin using the remote control press the On/Off key. By default the
remote control is set to receive and send data to the unit using RF
Channel 1. The BAS Crane Scale is set to the same RF channel
therefore; the remote control will communicate with the unit
automatically as soon as it turned on.
2. To change the remote’s RF Channel, RS232, or LCD settings, press
the MENU key and configure the remote with the appropriate settings.
Chapter 7: Remote Control (Optional)