Vertical Communications 8012S - Manual (Page 104)

Other Advanced Features
94 Comdial October, 02
7.6 Headset Jack
Your IP Speakerphone is equipped with a headset jack that provides
an interface for a headset. In order to properly operate a headset, you
must program a blank programmable button location on your IP
Speakerphone as a headset button. This headset button will perform
the enable/disable function for the headset. When the headset button
is enabled, all communications through your IP Speakerphone will be
done through the headset. If the headset button is disabled, the tele-
phone will perform as normal.
Figure 7-5 Headset Jack Location
• Program the headset button (at any blank programmable
button location) as follows:
1. Select OPTIONS.
2. Select Programming.
3. Select NEXT until the Feature Button option appears.
4. Select Feature Button.Programming Button
CAUTION
With the exception of a headset micro-
phone, do not connect the audio output of
any external device to the headset jack. Also, do not connect
the tip and ring leads of a telephone line to the headset jack. Do
not connect any devices to the headset jack other than those
mentioned above.
Connectors on Bottom of Telephone
Headset
Jack
AuxjckIP