Vertical Communications 8012S User Manual
Page 103
iPrimo Speakerphone Station User’s Guide
October, 02
Comdial
93
• To transfer a call to a pager park orbit for retrieval and
transmit the call’s park orbit code and caller ID information
(if available),
1. Answer the call and select Transfer.
2. Dial an extension number.
3. If the called station does not answer or is busy, select
TRACK.
4. Hear the confirmation beep (page accepted) or hear a busy
tone (page not accepted).
5. Press the SPEAKER button to end.
• To retrieve a call that you parked using the paging option,
1. Press the HOLD button to scroll your held calls, (display
shows PAGE and extension number of each parked call).
2. Press TAP to retrieve the displayed parked call.
• If you receive a parked call message on your pager unit,
1. Go to any system station.
2. Press INTERCOM.
3. Dial the pager orbit code (#800 to #899).
4. Retreive the call.
• To enable or disable a pager unit at your station,
1. Press INTERCOM.
2. Dial #07 to enable, or dial #06 to disable.
3. Press SPEAKER to end.
Note: Parked pager calls will recall to your station after a pre
programmed time-out. You can either place the call into
another page orbit or retrieve the call.