Rice Lake Versa-portion, Rice Lake Weighing Systems - Manual (Page 11)

Calibration 5
3.With the
ZERO
key held, press and release the
TARE
key, then press and
release the
POWER
key twice. 
The SPEC number is displayed.
4.To increment the SPEC setting value, press the
POWER
key. 
Refer to Table 3-1.
5.Press the
ZERO
key to save data and increase the SPEC count.
6.Press the
ZERO
key to advance to the next SPEC.
7.Press the
TARE
key to store SPECs and return to weigh mode.
SPEC
Number Bit 2 Bit 1 Bit 0
00 Decimal point position
000 - None
001 - 2nd digit (0.0)
010 - 3rd digit (0.00)
011 - 4th digit (0.000)
100 - 5th digit (0.0000)
101 ~ 111 - Not used
01 Minimum display
00 - 1
01 - 2
10 - 5
11 - 10 Net/gross multi-interval
0 - Gross
1 - Net
02 Resolution Selection
00 - 1/2000
01 - 1/3000
10 - 1/6000
11 - 1/7500 Weight single interval or
multi-interval
0 - Single interval
03 Decimal point figure for
numeral
0 - Period
1 - Comma Negative weight display
mask
0 - Minus gross > 9e
1 - Minus gross weight IR (inter resolution) mode
protected by SPAN SW
(SPAN switch must be
turned on for calibration)
0 - No
1 - Yes
04 Start range (amount of weight that can be on the
scale when it is turned on; if there is more weight
than allowed, the display will show all 8s)
00 - ±10% F.S. 10 - ±3%F.S.
01 - ±5% F.S. 11 - ±2%F.S. Re-zero range
0 - ±2% F.S.
1 - ±3% F.S.
05
Not NTEP
Approved
Manual tare cancellation
0 - Allow
1 - Prohibit Tare subtraction
0 - Allow
1 - Prohibit Tare accumulation
0 - Allow
1 - Prohibit
Table 3-1. SPEC Number And Bit Explanation (Defaults Are Bold)