Rice Lake TC Series, Rice Lake Weighing Systems - Operation Manual - Manual (Page 30)

RL-TC Series Operation Manual 25
8.3 Setting up Limit Values by Inputting Values
1 Starting the limit function Press and hold down the Target key.
Release the key when [
L
.
SEt
] is
displayed.
The currently set lower-limit value
flashes.
2 Opening the value input screen Press the Zero/Tare key.
All the digits are displayed, with the one
on the right end flashing. This flashing
digit is the one that can be changed.
3 Entering a value Press the Zero/Tare key again.
Pressing the key repeatedly changes the
flashing value until the desired number is
entered.
4 Selecting a digit Press the Function key.
The flashing moves to the digit on the
immediate left. Each time the key is
pressed, the flashing digit moves one
position left. When the leftmost digit is
selected, the flashing advances to the
rightmost digit position.
5 Repeat Steps 3 and 4 Enter the lower-limit value by selecting a
value with the Zero/Tare key and
moving the digits with the Function key,
as needed.
6 Saving the lower-limit value Press the Memory key.
After saving the lower-limit value, the
balance displays it briefly and proceeds
to the next setup.
※If one-point setup was chosen, the
setup is complete.
7 Setting up the upper-limit value The display changes to [
H
.
SEt
],
indicating that the upper-limit value can
be set.
If there is an upper-limit value already
set, that value will flash.