Rice Lake Star LC-7211 Form Printer - Manual (Page 27)

Micro feed 19
Micro feed
Use the following operation to feed the paper in very small increments. This
makes it possible to align the print head exactly where you want it.
❏
Make sure the printer is off-line ( ON LINE indicator is not lit).
❏
While holding down ON LINE , press LF to feed the paper forward or
MODE to feed the paper backward.
Setting the top of form position
The current position of paper loaded in the printer is automatically set as the top
of the page whenever you turn power on. You can also use the following
procedure at any time to specify a different position as the top of the page.
❏
Prepare either cut-sheet or fanfold paper for feeding.
❏
Press LF to feed the paper into the printer.
❏
Make sure the printer is off-line ( ON LINE indicator is not lit).
❏
Use the micro feed operations (see above) to move the paper so that the
print head is located where you want the new top of form position to be.
❏
While holding down FONT , press LF .
The printer will beep once to indicate that a new top of form position has
been set.
Setting the print mode
❏
Make sure the printer is off-line ( ON LINE indicator is not lit).
❏
Press the control panel’s MODE button to switch between NLQ ( DRAFT
indicator is not lit) and draft ( DRAFT indicator is lit) printing.
NLQ printing provides high quality, but is somewhat slower. Draft printing
is quicker, but the quality is not as good as NLQ.
Tear-off function (fanfold paper)
This procedure feeds fanfold paper to a position where it can be torn off easily.
❏
Make sure the printer is on-line ( ON LINE indicator is lit).
❏
Press the control panel’s MODE button.
❏
Tear off the paper.
❏
When you resume printing, the printer reverse feeds the paper to its former
position.
This operation causes the paper to be fed automatically so the tear assist edge of
the printer cover is aligned with the paper’s next perforation.