Rice Lake Livestock Solutions - AC/DC Power Supply Adapter Box Kit User Manual
Ac/dc power supply adaptor box kit, Portable animal scales, Mounting to scale
August 12, 2014
161397 Rev A
Portable Animal Scales
AC/DC POWER SUPPLY ADAPTOR BOX KIT
PN 156758
The following are instructions to install the AC/DC Power Supply Adapter Box on a portable animal scale.
Figure 1. AC/DC Power Supply Adapter Box Kit
Mounting to Scale
When ordering a complete package, the enclosure box will be assembled to the mounting bracket. If not, see
Step 3.
Figure 2. Mounting Power Box Assembly to Frame
The mounting bracket can be positioned anywhere along the frame within the limits of the conduit.
Note
Base Frame
of Scale
Angle Bracket
Backplate
Extensions
Bolts for securing
bracket to frame
Note
Table of contents
Document Outline
- Rice Lake Weighing Systems is an ISO 9001 registered company.
- AC/DC POWER SUPPLY ADAPTOR BOX KIT
- Figure 1. AC/DC Power Supply Adapter Box Kit
- Mounting to Scale
- Figure 2. Mounting Power Box Assembly to Frame
- 1. Place mounting bracket assembly on the outer beam of the bottom frame on the scale in desired location. Angle bracket should extend past the front of the beam and backplate extensions should be flush with back of beam.
- 2. Tighten bolts to secure to frame. Ensure they are tight enough to resist movement when scale is in use.
- 3. Mount the enclosure box to the mounting bracket using the bolts and washer supplied.
- 4. Disconnect the homerun cable from the weighcenter (see weighcenter manual PN 156758) and pull it out of the conduit and conduit elbow.
- 5. Insert the conduit elbow into the designated hole in the enclosure. Secure with nut.
- 6. Pass the weighcenter cable from the inside of the enclosure through the conduit elbow and conduit to the weighcenter.
- 7. Reconnect the cable to the weighcenter.
- 8. Disconnect the cable from the j-box.
- 9. Connect conduit elbow to the enclosure at designated hole and secure with nut.
- 10. Connect the other conduit elbow to the frame near the j-box.
- 11. Pass the j-box cable through the conduit elbow, supplied conduit and conduit elbow on the frame.
- 12. Reconnect the j-box cable to the j-box.
- 13. Connect the j-box cable connector and the weighcenter cable connector inside enclosure.
- 14. Secure connectors and excess cable with zip-ties inside the enclosure.
- AC/DC POWER SUPPLY ADAPTOR BOX KIT