Rice Lake Intercomp CS 5000 - Users Manual - Manual (Page 15)

CS5000, Users
Rev V, January, 2008
15
2: The IZSM (initial zero setting mechanism on power up) must be within +/- 10% of the
zero obtained at calibration.
3: The push-button zero and AZSM can only operate within +/- 2% of the IZSM.
4: The overcapacity point is 103% of capacity above the IZSM.
9. The scale shows “EE-05 EE-05 EE-05 EE-05”. Press the ZERO and PRINT keys. Enter the desired
graduation. Use the following table to select a graduation value. (Press the ZERO
and PRINT keys to enter this value.)
Setting Count by
in lb
Count by
in kg
0 100 50
1 50 20
2 20 10
3 10 5
4 5 2
5 2 1
6 1 0.5
7 0.5 0.2
8 0.2 0.1
9 0.1 0.05
10 0.05 0.02
11 0.02 0.01
NOTE: To meet stated accuracy statements, it is suggested that you choose your
graduation setting from the table below:
If your capacity is: Set your graduation to:
500 lb / 250 kg 0.2 lb / 0.1 kg (8)
1000 lb / 250 kg 0.5 lb / 0.2 kg (7)
2,000 lb / 1,000 kg 1 lb / 0.5 kg (6)
5,000 lb / 2,500 kg 1 lb / 0.5 kg (6)
10,000 lb / 5,000 kg 2 lb / 1 kg (5)
20,000 lb / 10,000 kg 5 lb / 2 kg (4)
30,000 lb / 15,000 kg 10 lb / 5 kg (3)
50,000 lb / 25,000 kg 10 lb / 5 kg (3)
70,000 lb / 35,000 kg 20 lb / 10 kg (2)
100,000 lb / 50,000 kg 20 lb / 10 kg (2)
Note: The changes will again be saved here and the scale could be turned off if you
don't wish to change the calibration.