Rice Lake Intercomp CS 5000 - Users Manual - Manual (Page 14)

CS5000, Users
Rev V, January, 2008
14
5. The scale displays “EE-01 EE-01 EE-01 EE-01”. Press the ZERO and PRINT keys. Enter the display
update rate (1 to 32), ('4' is suggested). The display update rate is the speed at
which the display is updated, with 1 being the fastest. (Press the ZERO and PRINT
keys to enter this number.
6. The scale displays “EE-02
EE-02 EE-02 EE-02”. Press the ZERO and PRINT keys. Enter what unit of
measure the scale should operate in; pounds or kilograms (0 to 1). (Press the
ZERO and PRINT keys to enter this number.)
Setting Units to operate in
0 pounds (lb)
1 kilograms (kg)
Note: At this point the changes you entered will be saved and the scale could be turned
off if you don't wish to change the calibration.
7. The scale shows “EE-03 EE-03 EE-03 EE-03”. Press the ZERO and PRINT keys. Enter the desired
AZT size. The AZT size is the number of graduations the auto zero tracking can
remove. Note: At this point if the calibration blocking switch is not in the enabled
position, the scale will not save the new AZT value. It will instead display the “E1
E1 E1 E1”
error message and return to normal weighing. See “Calibration switch” to
change this.
Setting AZT size
0 Off
1 0.6
2 1
3 3
8. The scale shows “EE-04 EE-04 EE-04 EE-04”. Press the ZERO and PRINT keys. The scale shows the
current Canadian specification selection. Use the following table to select the
Canadian specifications setting.
Setting Canadian
Specification
0 Off
1 On
A '0' setting implies normal operation:
1: AZT size is determined by setting of EE-03
EE-03 EE-03 EE-03.
2: Zero operates over full range of capacity.
3: Over capacity is 103% from the zero obtained at calibration.
A '1' setting implies Canadian specifications are used:
1: The AZT size fixed at 0.6d regardless of EE-03
EE-03 EE-03 EE-03 setting.