Rice Lake GX Series, A&D Weighing - Manual (Page 59)

57
11-4 Memory for Unit Mass in the Counting Mode
The data memory function can store 20 sets of unit mass for the counting mode. Even if the
AC adapter is removed, the data is maintained in non-volatile memory. Among the 20 sets,
“p01” is the memory function for the standard counting mode.
The unit mass in memory can be recalled and used for weighing.
The unit mass in memory can be recalled and changed.
Recalling the unit mass
1 Set the “Data memory ( data )” parameter to “1”.
2 Press the MODE key to select PC (counting mode).
Notes
If the counting mode can not be selected, refer to “4. WEIGHING UNITS”.
If “Clr” appears blinking in the upper left of the display, delete the data in memory.
3 Press and hold the PRINT key until the balance enters
the sample unit mass selection mode as shown below.
4 Select the unit mass to be used using the following keys.
RE-ZERO key To increase the unit mass number by one.
MODE key To decrease the unit mass by one.
PRINT key To select the unit mass number to be used.
CAL key To cancel the operation and go to step 5.
5 To re-store the unit mass or perform Automatic Counting Accuracy Improvement (ACAI) on
the stored unit mass, follow the procedure described in “5-2 Counting Mode (PC)”.
Note
ACAI can not be performed on the recalled unit mass.