Rice Lake RL150-10-5 Digital Physician Scale Technical & Operating Instructions - Manual (Page 9)

Rice Lake Digital Physician Scale — Scale Assembly 5
Wheel Assembly
Attach the wheel assembly to the scale prior to connecting the second column. To attach the wheels, use the
following steps.
1. Attach the two wheels to the wheel assembly rod, as shown in Figure 3-4.
Figure 3-4. Attach Wheel Assembly
2. Attach the wheel assembly to the scale using a Phillips head screw and tighten with a screwdriver.
Attach Second Column to First Column
Once the wheel assembly is attached, finish the scale assembly using the following steps.
Plug conn ector into
upper column.
Note
Ensure that the cable is extending through the top of the lower column so that it can be plugged into the
second (upper) column.
Figure 3-5. Extend Cable Through Scale Column
3. Once the cable is connected, insert and slide the upper column onto the lower column as shown in
Figure 3-6, making sure that the screw holes are lined up and that the cable does not get pinched.
Make sure that screw
holes are lined up.
Figure 3-6. Insert Upper Column into Lower Column
4. Insert two screws and tighten using a Phillips head screwdriver.