Code 11 set length 2, Code 11 — cont – Rice Lake Datalogic PowerScan PD7100 Series Laser Scanner User Manual
Page 250
Symbologies
242
PowerScan
®
PD7100 Corded
Code 11 Set Length 2
This feature specifies one of the barcode lengths for
is the maximum label length if in
Mode, or the second fixed length if
in
Mode. Length includes the barcode’s check and data characters.
The length can be set from 2 to 50 characters. A setting of 0 specifies to ignore this length
(only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 2 to 50 — or 0 to ignore this
length). Pad the number with leading zeroes to yield two digits. For example: 0 =
00, 5 = 05, 20 = 20, etc.
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program-
ming Mode.
3. Scan the barcode: SELECT CODE 11 LENGTH 2 SETTING.
4. Scan the appropriate two digits from the keypad in
, that rep-
resent the length setting which was determined in the steps above. You will hear a
two-beep indication after the last character.
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
ming Mode.
This completes the procedure. See
for some examples of how to set this feature.
Table 32. Code 11 Length 2 Setting Examples
NOTE
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
STEP
ACTION
EXAMPLES
1
Desired Setting (pad with leading
zeroes)
00 (Ignore This
Length)
07 Characters
15 Characters
50 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT CODE 11 LENGTH 2 SETTING
4
Scan Two Characters From
‘0’ and ‘0’
‘0’ and ‘7’
‘0’ and ‘F’
‘3’ AND 2’
5
Scan ENTER/EXIT PROGRAMMING MODE