Rice Lake Bariatric/Handrail with Chair Seat (240-10-1) - Manual (Page 8)

4 Bariatric Handrail Scale Operation Instructions
AC Power Connections
The Digital Bariatric Handrail Scale has a 120 VAC adaptor or 230 VAC adaptor to use when power is readily
available. The AC power adaptor plugs into the back of the indicator as shown in Figure 2-2.
Connect the AC power
source here
L E D in d i c a t o r l i g h t
illuminates from red to
green when charged
Store the 120 VAC
adaptor here when
not in use
RS-232 port
connection
Store the 230 VAC
adaptor here when
not in use
Back cover to
indicator
Retaining Screw
Figure 2-2. LED Light Location
The AC adaptor, when not in use, plugs into the back housing of the indicator for storage. Figure 2-2 shows that
location.
The Digital Bariatric Handrail Scale is capable of running its internal sealed lead-acid rechargeable battery if no
additional power source is available. Battery life is approximately 75 hours. If the
LO Bat
indicator is showing on
the display, recharge the battery or connect the scale to an AC power source as soon as possible for accurate
weighing.
Battery Charging
When the AC adaptor is connected to a power source, the rechargeable battery goes into recharge mode.
NOTE: To maintain battery longevity we recommend you charge it on a regular basis rather than waiting until it is fully
discharged.
The LED indicator light on the back of the scale housing will illuminate red during the charging period, and
change over to green when the battery becomes fully charged.
Attaching the Indicator to the Scale Handle
Use the following steps to attach the indicator to the scale.
1. Unscrew the four back cover screws, remove the back cover and place screws in a secure place along
with the back cover. The screw location is shown in Figure 2-3.
2. Unscrew the six screws on the back panel plate of the scale and position the indicator to it and screw