Rice Lake 920i Programmable HMI Indicator/Controller - WLAN - Manual (Page 9)

9
14. The screen automatically goes to end the screen which gives the choice to Save and Exit (
9
) and is shown
below. By selecting that choice, and pressing
Enter
, the WLAN parameters are saved and the screen
becomes greyed out as is shown below.
Figure 18. Save and Exit Screen
Once all of the data is saved, you must switch the jumpers back to the OFF position (Figure 4) to exit out of the
configuration mode.
Now you can access and view all wireless data on the PC.
Enclosure Reassembly
Once cabling is complete, position the backplate over the enclosure and reinstall the backplate screws. Use the
torque pattern shown in Figure 19 to prevent distorting the backplate gasket. Torque screws to 15 in-lb. (1.7 N-m).
Figure 19. 920i Enclosure Backplate (shown)
5PSRVFCBDLQMBUFTDSFXT
UPJOMC /N