Rice Lake 920i Programmable HMI Indicator/Controller - WLAN - Manual (Page 5)

5
The WLAN configuration port uses the following settings:
• Baud Rate - 9600
• 8 Bits
• No Parity
• 1 Stop Bit
• No Flow Control
Make the changes and press
OK
to save those changes.
5. Reset the WLAN option card by pressing the manual reset button, and immediately upon release enter
three lowercase
x
characters (
xxx
) at the same time. The manual reset button location is shown in Figure 8.
Figure 8. Manual Reset Button Location on WLAN Option Card
NOTE: The easiest way to connect is to hold down the x key on the PC’s keyboard until the manual reset button is released and the
PC screen displays the MAC address and software version as shown in Figure 9. This must be done within three seconds of
resetting the WLAN option.
Upon a successful connection, the following information is displayed.
Figure 9. Display Information for Setup Mode
6. To enter Setup Mode, press
Enter
within five seconds. Note that the connection will fail if
Enter
is not
pressed within the five second time limit. The configuration settings display, followed by the setup menu
options. If this happens, repeat Step 5.
7. Select an option on the menu by entering the number of the option in
Your Choice?
field and press
Enter
. In
Manual Reset Button