Rice Lake 920i Installation Manual V3.12 - Manual (Page 39)

Configuration 33
Figure 3-7. SCALES Menu, CALIBR Submenu
See the
iQUBE
Installation Manual, PN 77224, for information about configuring
iQUBE
scales.
UNITS LB
KG
G
OZ
TN
T
GN
TROYOZ
TROYLB
LT
CUSTOM
NONE
OFF Specifies primary units for displayed and printed weight. Values are: LB=pound;
KG=kilogram; G=gram; OZ=ounce; TN=short ton; T=metric ton; GN=grain; TROYOZ=troy
ounce; TROYLB=troy pound; LT=long ton.
SCALES Menu, CALIBR Submenu
Parameter Choices Description
Level 4, CALIBR submenu
WZERO — Press ENTER to display and edit the zero calibration A/D count or millivolts value.
WVAL — Press ENTER to display and edit the test weight value.
WSPAN — Press ENTER to display and edit the span calibration A/D count or millivolts value.
WLIN POINT 1 —
POINT 5 Press ENTER to display and edit test weight and calibration values for up to five linearization points.
Perform linear calibration only after WZERO and WSPAN have been set.
REZERO — Press ENTER to remove an offset value from the zero and span calibrations.
NOTE: Use this parameter only after WZERO and WSPAN have been set. See Section 4.2 on
page 52 for more information about using this parameter.
Table 3-5. SCALES Menu, CALIBR Submenu Parameters
SCALES Menu, FORMAT Submenu, SPLIT
≠
OFF
Parameter Choices Description
Table 3-4. SCALES Menu, FORMAT Submenu Parameters, SPLIT ≠ OFF (Continued)
WZERO WVAL WSPAN WLIN REZERO
POINT 4 POINT 5 POINT 1 POINT 2 POINT 3
VISIBLE GRADS FORMAT CALIBR
… …