ProgressiveRC 6S PowerLog User Manual
Page 8
-8-
Multifunctional Monitor & Logger PowerLog 6S
TYPE
XXXXXXXXXX
LOGS
0
RATE
:2.0
[1988Kb/16h:34]
Logs OFF
QUICK START
PowerLog Power On
When connecting any of the following power sources, PowerLog will be triggered ON:
1. Connect the USB port of PC
2. Connect power supply(4.5-60V) through T-plug T1 or T2
3. Connect J1,J2 with 5V power supply.
4. Connect power supply trough Multiple Voltage Input Port (J3), PIN1 connect the negative polarity of the
power supply, PIN2-PIN7 connect with 4.5-28V voltage.
System self-check, and then shows the SN and version number, the displayed information is as below:
The first line is the current selected Setting Type (See
details in P13). The second line shows the log file
number. And the third line is the available record of
capacity and time. The last line shows the current log file
name (if no files, it shows “Logs OFF”). 3 seconds later,
the system enters voltage monitor status.
Monitor
There are 5 interface choices, which can be shifted by < > button.
1) Watt Monitor
Monitor the input voltage and current of
T-plug
Current zero point calibration:
When there is no current flowing through T-Plug, if the
displayed
current
is
not
zero,
please
press
<▲>+<▼>+< > for 3 seconds. (<▲>+<▼>+< > means
pressing <▲> and <▼>+< > at the same time.)
Reset Timer
Press <▲>+<▼> for 3 seconds, the time on the upper right
corner becomes 00m:00 and the capacity on the upper left
corner becomes 0mAh.
Press<▲>or<▼>, can shift between the interface of the
current value and the peak value.
Reset peak value
Press<▲>+<▼>, the Min. and Max. peak value will be
replaced to be the current value.
Setting range
T-plug Voltage: 4.5—60V Current : -130A—+130A
Capacity: 0—999999mAh Power : -7800W—+7800W
Alarm Configuration Name
Existent Log Files Number
Free Capacity/Free Time
Current Log File Name
Record Interval Time
003015mAh 20M:10
10.50A
12.01V 126.1W
Timer
Current
Power
Capacity
T-plug Voltage
PEAK Min. / Max.
0.00A 10.80A
11.53V 12.32V
0W 127.3W
<▢> or<▼>