Cisco Cisco Unified Wireless IP Phone 7921G - Manual (Page 75)

Using a Handset, Headset, and Speakerphone
Cisco Unified Wireless IP Phone 7921G Phone Guide for Cisco Unified Communications Manager 7.0 67
Obtaining Headsets
Your phone supports wired headset jack types with a 2.5 mm, 3-band/ 4 connector. For information
about purchasing headsets, see
Headset Information, page 14 .
Using AutoAnswer
You might use AutoAnswer if you receive a high volume of incoming calls or handle calls on behalf of
others. Your system administrator configures AutoAnswer to work with either your speaker mode or
headset.
If you... Then...
Use AutoAnswer with a
headset Keep headset mode active by ensuring the headset is plugged into the
phone, even when not on a call.
If your phone is set up to use AutoAnswer in headset mode, calls are
answered automatically only if the wired headset
icon is in the
phone status line. Otherwise, calls ring normally and you must
manually answer them.
Use AutoAnswer with the
desktop charger speaker Keep the handset in the desktop charger cradle, so the speaker is active.
If your phone is set up to use AutoAnswer in speaker mode, calls are
answered automatically using the desktop charger speaker.
Note You cannot turn off the desktop charger speaker. You must remove
the phone from the cradle to disable the desktop charger speaker.