Mercedes-Benz M-Class 2006 Owners Manual - Manual (Page 295)

294
Controls in detail
Useful features
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
̈ Continue to press and hold the
integrated signal transmitter button
(
1, 2 or 3) while you press and
re-press (“cycle”) your hand-held
remote control transmitter
6 every
two seconds until the frequency signal
has been learned. Upon successful
training, the indicator lamp
4 will
flash slowly and then rapidly after
several seconds.
̈ Proceed with programming step 5 and
step 6 to complete.
Operation of remote control
̈ Switch on the ignition ( ୴ page 34).
̈ Select and press the appropriate
integrated signal transmitter button
(
1, 2 or 3) to activate the remote
controlled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
̈ Switch on the ignition ( ୴ page 34).
̈ Simultaneously hold down the signal
transmitter buttons
1 and 3, for
approximately 20 seconds, until the
indicator lamp
4 flashes rapidly. Do
not hold for longer than 30 seconds.
The codes of all three channels are
erased.
i
If you sell your vehicle, erase the codes
of all three channels.