Mercedes-Benz M-Class 2006 Owners Manual - Manual (Page 293)

292
Controls in detail
Useful features
Step 3:
̈ Hold the end of the hand-held remote
control transmitter
6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control
located on the left side of the interior
rear view mirror, keeping the indicator
lamp
4 in view.
Step 4:
̈ Using both hands, simultaneously
press the hand-held transmitter
button
5 and the desired integrated
signal transmitter button ( 1, 2
or 3). Do not release the buttons until
completing step 5.
The indicator lamp 4 on the
integrated remote control will flash,
first slowly and then rapidly.
Step 5:
̈ When the indicator lamp 4 flashes
rapidly, release both buttons.
Step 6:
̈ Press and hold the just-trained
integrated signal transmitter button
and observe the indicator lamp
4.
If the indicator lamp 4 stays on
constantly, programming is complete
and your device should activate when
the integrated signal transmitter
button is pressed and released.
Step 7:
̈ To program the remaining two buttons,
repeat the steps above starting with
step 3.
i
The indicator lamp 4 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after
20 seconds.
i
If the indicator lamp 4 flashes rapidly
for about two seconds and then turns
to a constant light, continue with
programming steps 8 through 12 as
your garage door opener may be
equipped with the “rolling code”
feature.
୴୴