beautypg.com

Mini-dt troubleshooting guide – Losi LOSB0202T3 Quick Start User Manual

Page 3

background image

Mini-DT Quick Start Guide―Page 3

Doesn’t operate

Battery not charged or plugged in

Charge battery / plug-in

Receiver switch not “on”

Turn on receiver switch

Transmitter not ‘on” or low battery

Turn on / replace batteries

Motor runs but rear

Pinion not meshing with spur gear

Adjust pinion/spur mesh

wheels don’t move

Pinion spinning on motor shaft

Replace pinion gear on motor

Slipper too loose

Check & adjust slipper

Transmission gears stripped

Replace transmission gears

Drive pin in axle missing

Check & replace

Steering doesn’t work

Servo plug not in receiver

Check if plug in / all the way

Servo gears or motor damaged

Replace or repair servo

Won’t turn one direction

Servo gears damaged

Replace servo gears

Motor doesn’t run

Motor plugs loose

Plug in completely

Motor wire broken

Repair or replace as needed

ESC damaged

Call Electronics Tech

ESC gets hot

Motor over-geared

Put smaller pinion on motor

Driveline bound up

Check wheels & trans for binds

Poor run time and/or

Battery pack not fully charged

Recharge

sluggish acceleration

Charger not allowing full charge

Try another charger

Slipper slipping too much

Check/adjust slipper

Motor worn out

Replace motor

Driveline bound up

Check wheels & trans for binds

Poor range/glitches

Transmitter battery low

Check & replace as necessary

Transmitter antenna loose

Check & tighten

Battery low in truck

Replace or recharge

Loose plugs or wires

Check motor and power plugs

Slipper won’t adjust

Drive pin missing in shaft

Replace drive pin

Spur gear face worn out

Replace spur gear & adjust slipper

Warranty Period

Exclusive Warranty- Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “Product”) will be free from

defects in materials and workmanship at the date of purchase by the Purchaser.

Limited Warranty

(a) This warranty is limited to the original Purchaser (“Purchaser”) and is not transferable. REPAIR OR REPLACEMENT

AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. This warranty covers

only those Products purchased from an authorized Horizon dealer. Third party transactions are not covered by this warranty.

Proof of purchase is required for warranty claims. Further, Horizon reserves the right to change or modify this warranty

without notice and disclaims all other warranties, express or implied.

(b) Limitations- HORIZON MAKES NO WARRANTY OR REPRESENTATION, EXPRESS OR IMPLIED, ABOUT NON-

INFRINGEMENT, MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OF THE PRODUCT. THE

PURCHASER ACKNOWLEDGES THAT THEY ALONE HAVE DETERMINED THAT THE PRODUCT WILL SUITABLY MEET

THE REQUIREMENTS OF THE PURCHASER’S INTENDED USE.

(c) Purchaser Remedy- Horizon’s sole obligation hereunder shall be that Horizon will, at its option, (i) repair or (ii) replace,

any Product determined by Horizon to be defective. In the event of a defect, these are the Purchaser’s exclusive remedies.

Horizon reserves the right to inspect any and all equipment involved in a warranty claim. Repair or replacement decisions

are at the sole discretion of Horizon. This warranty does not cover cosmetic damage or damage due to acts of God,

accident, misuse, abuse, negligence, commercial use, or modification of or to any part of the Product. This warranty does

not cover damage due to improper installation, operation, maintenance, or attempted repair by anyone other than Horizon.

Return of any goods by Purchaser must be approved in writing by Horizon before shipment.

Damage Limits

HORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES, LOSS OF PROFITS OR

PRODUCTION OR COMMERCIAL LOSS IN ANY WAY CONNECTED WITH THE PRODUCT, WHETHER SUCH CLAIM

IS BASED IN CONTRACT, WARRANTY, NEGLIGENCE, OR STRICT LIABILITY. Further, in no event shall the liability of

Horizon exceed the individual price of the Product on which liability is asserted. As Horizon has no control over use, setup,

final assembly, modification or misuse, no liability shall be assumed nor accepted for any resulting damage or injury. By the

act of use, setup or assembly, the user accepts all resulting liability.

Mini-DT Troubleshooting Guide

Mini-DT Troubleshooting Guide

This manual is related to the following products: