Losi LOSB0202T3 Quick Start - Manual

Mini-DT Quick Start Guide―Page 1
Getting Started
NOTE:
Getting Started
Step 1
Step 3
Step 4
Step 2
Before you start running your new Mini-DT, it is absolutely necessary that you read
through all of the operating instructions to prevent unnecessary damage and get the
maximum enjoyment from your vehicle.
Plug the AC charger into the proper wall receptacle (110V).
Plug the battery pack into the charger and let it charge for
3 hours for the first time. After running, or when the Mini-DT
slows noticeably, recharge the battery pack for 5-6 hours for
a full charge.
Remove the transmitter battery cover by sliding the cover
from left to right. Install eight (8) AA batteries into the
battery holder. Pay close attention to the correct direction
of the positive (+) and negative (-) ends as marked in the
tray. Once all 8 batteries have been installed, reinstall the
battery cover by sliding it on from right to left.
Insert the antenna wire through the antenna mount and
into the antenna tube (fig. 1) pushing it through until it
comes out the other end. Push the antenna tube (fig. 2)
into the antenna mount.
Once the battery
is charged,
remove the
body clip from
the front of the
battery tray (fig.
3) and lift up the
front of the tray
(fig. 4). Install
the battery pack
as shown (fig.
5), reinstall the
body clip and
plug the battery
pack into the
ESC.
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5