Step 5 step 6 step 7 – Losi LOSB0202T3 Quick Start User Manual
Page 2

Mini-DT Quick Start Guide―Page 2
Always turn on the transmitter first by sliding the switch
on the left side of the wheel from left to right. The small
red and green lights above the switch should both light
up. If not, check for low or incorrectly installed batteries.
Once the transmitter has been turned on, turn on the
Mini-DT by sliding the switch on the speed controller to
the “On” position. If the rear wheels turn, adjust the “TH.
Trim” knob located to the lower right of the steering wheel
until they stop. To go forward, pull the trigger back. If you
should need reverse, wait for the model to stop then push
the trigger forward. When going forward the model should
move in a straight line. If not, adjust the “ST. TRIM” so that
it tracks in a straight line without having to turn the steering
wheel. After you are have finished, turn the Mini-DT off
FIRST
by sliding the switch to the “OFF” position. After
the model has been turned off, turn off the transmitter. If
you wish to clean your Mini-DT, use compressed air and/
or a soft paintbrush to remove dust and dirt.
NEVER
use
chemicals or anything wet as it can cause damage to both
electronics and plastic parts.
ALWAYS
• Turn on the transmitter before the vehicle
• Use caution when running your vehicle near
people
• Turn both the Mini-DT and transmitter “off”
when done
• Check the battery condition of the transmitter
before running
NEVER
• Operate the Mini-DT with low battery power
• Run the Mini-DT through water or wet grass
• Use chemicals to clean the chassis
• Run the Mini-DT without a gear cover
Step 5
Step 6
Step 7
The On/Off switch for the receiver/ESC is located on the
right side toward the back of the unit. Locate the switch
and slide the switch lever back to the “ON” position,
which is clearly marked on the side of the switch. The
Mini-DT should now be powered up. If not refer to the
Troubleshooting Guide for help in locating the cause.
Safety Precautions
This is a sophisticated hobby Product and not a toy. It must be operated with caution and common sense and requires some
basic mechanical ability. Failure to operate this Product in a safe and responsible manner could result in injury or damage to
the Product or other property. This Product is not intended for use by children without direct adult supervision. The Product
manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and
warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or injury.
Questions, Assistance, and Repairs
Your local hobby store and/or place of purchase cannot provide warranty support or repair. Once assembly, setup or use of
the Product has been started, you must contact Horizon directly. This will enable Horizon to better answer your questions
and service you in the event that you may need any assistance. For questions or assistance, please direct your email to
[email protected], or call 877.504.0233 toll free to speak to a service technician.
Off/On
St.Trim
Th.Trim
Left
Right
Brake/Reverse
Forward