Losi LOSB0103 User Manual
Page 6
10
11
Battery Pack(s)
To install the battery pack remove the battery hold-down strap by removing the clip from the front mounting boss, and then, while
lifting the strap, pulling forward in one motion.
After you have inserted the fully charged battery pack reinstall the battery hold-down strap.
Notice that the battery hold-down has a flat side while the other side has strengthening ribs; the rib side should be facing
down to the battery.
Insert on an angle into the rear support, and then down on the front pin and secure it with the previously removed clip.
Note: Please read the entire manual to gain a full understanding of the 1/10 HIGHroller
vehicle, fine-tuning the setup and performing maintenance.
1. Read the safety precautions found on page 3. This is important for your safety and
prevention of personal injury.
2. Charge the battery pack you have chosen (NOT INCLUDED). Refer to the
manufacturer’s supplied instructions for battery charging information.
3. Install the AA batteries (NOT INCLUDED) into the Losi 27MHz AM transmitter (see page
9). Use alkaline or rechargeable batteries only.
4. Install the battery pack (see previous page). The battery pack should be fully charged
before installation.
5. Turn on the transmitter and then the vehicle. It is a good practice to
turn on the transmitter before the vehicle and turn it off after the vehicle has
been turned off.
6. Check steering (see page 12). Verify that the servo is functioning properly.
7. Driving the 1/10 HIGHroller (see page 14).
8. Performing maintenance of the 1/10 HIGHroller. Refer to Tuning, Adjusting and
Maintenance of the 1/10 HIGHroller on page 15.
Quick Start