La-Z-Boy La-Z-Touch Cooler Recliner with Massage & Heat prior to 11/27/2011 - Manual (Page 4)

Ther mo-Electr ic Cooler Recliner with 2-Motor
Massage & Heat Assembly Instr uctions:
7 6
-- To reduce the risk of injur y:
• Do not operate the unit until the back is installed and locked.
NOTICE:
Do not plug in until instructed.
1. Install the back.
• Lay the back across the chair ar ms . Lift the back at a slight angle and align
the brackets on the back with the brackets on the body (F IGURE 1).
• Lower the back onto the body, making sure the back and body brackets are
completely engaged.
• To make sure the back is proper ly installed, with both sets of back
and body brackets engaged, stand behind the chair and twist the
back from side to side. If one or both sides move out of position,
the brackets are not engaged (F IGURE 2). Remove the back and
repeat the steps a bove.
• If you are unable to install the back properly, contact your La-Z-Boy ®
dealer for assistance.
• Lock the brackets by using a screwdriver to push down the locking levers (F IGURE 3).
2. The ther mo-electr ic cooler power transfor mer, 2-motor massage and heat power
transfor mer and r ubber mat are stored inside the cooler dur ing shipping. Remove
the power transfor mer s from the cooler and unwind the cords .
-- To reduce the risk of product damage:
• Before operating, remove the w hite packing mater ial located under
the cooler, inside the ar m cavity.
3. Packing mater ial is used under the ther mo-electr ic cooler to protect and suppor t
the cooler during shipping. The packing material must be removed before operating
the cooler to prevent damage. Lift the ther mo-electr ic cooler from the chair ar m
and set in the seat (F IGURE 4). Remove the w hite packing mater ial from inside the
ar m cavity (F IGURE 5).
4. Carefully lower the ther mo-electr ic cooler into the chair ar m, making sure the
power connector is toward the back of the chair (F IGURE 6).
5. To access the massage connector s , stand at the side of the chair and push
the back rearward to recline the seat and back. Hold the top ar m closed to
prevent the cooler from falling out, and gently tip the chair forward to rest
on its ar ms and the top of the back.
(Assembly Instructions Continued)
Ther mo-Electr ic Cooler Recliner with 2-Motor
Massage & Heat Assembly Instr uctions:
WARNING
NOTICE :
F I G U R E 2
F I G U R E 4 F I G U R E 3
F I G U R E 1
F I G U R E 6 F I G U R E 5
White Packing
Mater ial
Ther mo-Electr ic Cooler
Power Connector
Body
Bracket
Back Bracket
Back and body brackets on this
side are not engaged. Remove
the back and reinstall.
Back
Bracket
Locking
Lever
Locked
Position
Chair
Back