Serial ata and power connector, Frame for drive mounting, Elongated holes for hdd mounting – Kontron KISS Stor 0/5 User Manual
Page 28: Docking connector of the drive carrier
Components of the KISS-Stor 0/5
KISS-Stor 0/5 – User’s Manual
27
Serial ATA and Power Connector
This connector is the SATA device connection via a SATA 7-pin signal connector
with a separate SATA 15-pin power connector.
Frame for Drive Mounting
The frame provides mechanical support for the SATA HDD drive. The drive will be
mounted in the frame and will be held in place with four screws.
Elongated Holes for HDD Mounting
The elongated holes allow you to secure the SATA hard disk properly into the
frame of the removable drive carrier by use of the supplied inch screws. The
mounting holes are laterally accessible, and correspond to the laterally provided
mounting holes of the SATA HDD.
Use only the inch screws supplied. Two screws on each
side are sufficient to secure the SATA hard disk into the
frame of the drive carrier.
Docking Connector of the Drive Carrier
This connector allows you to dock the drive carrier to the drives cage of the KISS-
Stor 0/5.