Kontron KTQM87-mITX - Manual (Page 42)

KTD-N0886-A Page 40 Internal Connectors
KTQM87/mITX Users Guide
Warning
Don’t leave the jumper in
position 1-2, otherwise if power
is disconnected, the battery will
fully deplete within a few weeks.
“Load Default BIOS Settings” Jumper (J5) 7.12
The “Load Default BIOS Settings” Jumper (J5) can be used to recover from incorrect BIOS settings. As an
example, an incorrect BIOS setting which causes the attached display not to turn on can be erased by this
Jumper.
The Jumper has 3 positions: Pin 1-2, Pin2-3 (default position) and not mounted.
Jumper (in default position)
J5 pin1
J5
Description
pin1-2 pin2-3
X - Don’t use. (Board do not boot with jumper in this position)
- X Default position
- - Load Default BIOS Settings and erase Password
To Load Default BIOS Settings and erase password:
1. Turn off power completely (no SB5V).
2. Remove the Jumper completely from J5.
3. Turn on power.
4. Motherboard beeps fast 20 times and turns off.
5. Turn off power.
6. Move the Jumper back to position 2-3 (default position).
7. Turn on power, use the Power On Button ( PWRBTN_IN#) if required to boot.
Motherboard might automatically reboot a few times. Wait until booting is completed.
!