Kontron KTH81-mITX - Manual (Page 9)

KTD-N0882-H Page 9 Introduction
KTQ87/KTH81 Users Guide
1 Introduction
This manual describes the KTH81/mITX, KTQ87/mITX, KTH81/Flex & KTQ87/Flex boards made by KONTRON
Technology A/S. The boards will also be denoted KTQ87 & KTH81.
The KTQ87/KTH81 boards are based on the Q87/H81 chipsets supporting 4
rd generation Intel® Haswell i7 -,
i5 2Core and 4Core desktop processors, Haswell Dual Core Pentium and Haswell Dual Core Celeron. See
“Processor Support Table” for more specific details.
The differences between the four types of boards are listed in this table:
Feature KTH81/mITX KTQ87/mITX KTH81/Flex KTQ87/Flex
Form factor mITX mITX Flex ATX Flex ATX
PCIex16 Gen2 Gen3 Gen2 Gen3
Vpro - Depends on CPU - Depends on CPU
AMT - Yes - Yes
RAID - Yes - Yes
DP 2x (DP0, DP1) 3x (DP0, DP1,DP2) 2x (DP0, DP1) 3x (DP0, DP1,DP2)
LVDS - - Yes (=> no DP1) Yes (=> no DP1)
USB
2x USB3.0/2.0
8x USB2.0
4x USB3.0/2.0
6x USB2.0
2x USB3.0/2.0
8x USB2.0
4x USB3.0/2.0
8x USB2.0
LPC - - 2x10 pin row 2x10 pin row
DIMM slots 2x 2x 2x 4x
PCIe slots
PCIex16, Gen2.
mPCIe (w. USB)
PCIex16, Gen3
mPCIe (w. USB)
PCIex16, Gen2
PCIex2 (x16 slot)
+ PCIex1
PCIex16, Gen3
PCIex4 (x16 slot)
+ PCIex1
mSATA 1x (w. USB, LPC) 1x (w. USB,LPC) - -
SATA
1x Gen3
2x Gen2
5x, Gen3
2x Gen3
2x Gen2
6x, Gen3
PCI Slot - - 1x 1x
Kbd/Mse - - 6-pin row 6-pin row
Fan connectors CPU, Sys CPU, Sys CPU, Sys1, Sys2 CPU, Sys1, Sys2
Use of this Users Guide implies a basic knowledge of PC-AT hard- and software. This manual is focused on
describing the KTQ87 / KTH81 board’s special features and is not intended to be a standard PC-AT textbook.
New users are recommended to study the short installation procedure stated in the following chapter
before switching-on the power.
All configuration and setup of the CPU board is either done automatically or manually by the user via the
BIOS setup menus. Only exceptions are the “Clear CMOS” Jumper and the “Always On” jumper.
Latest revision of this manual, datasheet, BIOS, drivers, BSP’s (Board Support Packages), Mechanical
drawings (2D and 3D) can be downloaded from here:
http://www.kontron.com/products/boards-and-
mezzanines/embedded-motherboards/