Kontron CP6002 IPMI - Manual (Page 40)

IPMI Firmware User Guide CP6002
Page 40 ID: 1039-1613, Rev. 2.0
The following table describes the functioning of the Module Management LEDs.
Table 13: Module Management LEDs Function
LED COLOR STATE NORMAL MODE
OVERRIDE MODE
selectable by user or
SMS/SMM
LED I0 green off IPMI Controller operating By user:
• Only lamp test
slow blinking IPMI Controller request attention of the
SMS/SMM
fast blinking Send/receive data through the IPMB bus
on steady IPMI Controller not operating
LED I1 green off IPMI Controller not operating By user:
• Only lamp test
slow blinking IPMI Controller heart beat
fast blinking Send/receive data through the KCS interface
on steady Health error detected
HS LED
(Hot Swap
LED) blue off Module is in normal operation
(do not extract the module) By SMS/SMM:
• On
• Off
• Slow/Fast Blinking
By user:
• Only lamp test
blinking Module hot swap in progress;
module not ready for extraction
on a) Module ready for hot swap extraction, or
b) Module has just been inserted in a powered
system