beautypg.com

General information – Jeep 2015 Wrangler - Owner Manual User Manual

Page 21

background image

sound. In addition, the Vehicle Security Light will

begin to flash. Turn the ignition switch to the LOCK

position and remove the second key.

4. Insert a blank Sentry Key® into the ignition switch.

Turn the ignition switch to the ON/RUN position

within 60 seconds. After 10 seconds, a single chime

will sound. In addition, the Vehicle Security Light will

stop flashing. To indicate that programming is com-

plete, the Vehicle Security Light will turn on again for

three seconds and then turn off.

The new Sentry Key® is programmed. The Remote

Keyless Entry (RKE) transmitter will also be pro-
grammed during this procedure.
Repeat this procedure to program up to eight keys. If you

do not have a programmed Sentry Key®, contact your

authorized dealer for details.

NOTE:

If a programmed key is lost, see your authorized

dealer to have all remaining keys erased from the sys-

tem’s memory. This will prevent the lost key from

starting your vehicle. The remaining keys must then be

reprogrammed. All vehicle keys must be taken to an

authorized dealer at the time of service to be repro-

grammed.

General Information

The Sentry Key® system complies with FCC rules part 15

and with RSS-210 of Industry Canada. Operation is

subject to the following conditions:

• This device may not cause harmful interference.
• This device must accept any interference that may be

received, including interference that may cause unde-

sired operation.

2

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 19