beautypg.com

To set a desired speed, To deactivate, To resume speed – Jeep 2015 Wrangler - Owner Manual User Manual

Page 185: To vary the speed setting

background image

WARNING!

Leaving the Electronic Speed Control system on
when not in use is dangerous. You could accidentally
set the system or cause it to go faster than you want.
You could lose control and have an accident. Always
leave the system OFF when you are not using it.

To Set A Desired Speed

Turn the Electronic Speed Control ON. When the vehicle

has reached the desired speed, push the SET (-) button

and release. Release the accelerator and the vehicle will

operate at the selected speed.
NOTE:

The vehicle should be traveling at a steady speed

and on level ground before pushing the SET (-) button.

To Deactivate

A soft tap on the brake pedal, pushing the CANCEL

button, or normal brake pressure while slowing the

vehicle will deactivate the Electronic Speed Control with-

out erasing the set speed from memory.
Pushing the ON/OFF button or turning the ignition

switch OFF erases the set speed from memory.

To Resume Speed

To resume a previously set speed, push the RES (+)

button and release. Resume can be used at any speed

above 20 mph (32 km/h).

To Vary The Speed Setting

To Increase Speed
When the Electronic Speed Control is set, you can in-

crease speed by pushing the RES (+) button.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 183