Installing the soft top — two-door models – Jeep 2015 Wrangler - Owner Manual User Manual

Page 198

4. Disconnect the knuckles from the left and right metal

pivot brackets. Remove the soft top from the vehicle

and store in a clean, dry location.

NOTE:

To aid in disconnecting the knuckles, you may

carefully tap on the knuckles using a rubber mallet.

5. Unzip the zipper on the sport bar cover to expose the

pivot brackets. Remove the brackets using a #T30

Torx® head driver. Recover and re-zip the sports bar

cover. Store the pivot brackets and screws in a safe

place.

6. Reinstall the hard top. Refer to “Freedom Top™ Three-

Piece Modular Hard Top — Front/Rear Panel Instal-

lation” in this section.

Installing The Soft Top — Two-Door Models

NOTE:

The following procedures are for first time set up

only. For future soft top procedures, refer to “Soft Top” in

this section.
1. Locate and remove the following items prior to hard

top removal:

• Right and left door frames
• Door frame attachment knobs (four for two-door

models, six for four-door models)

196 UNDERSTANDING THE FEATURES OF YOUR VEHICLE