Jeep 2015 Wrangler - Owner Manual - Manual (Page 130)

Place/Retrieve A Call From Hold
To put a call on hold, push the Phone
button until
you hear a single beep. This indicates that the call is on
hold. To bring the call back from hold, push and hold
the Phone button until you hear a single beep.
Toggling Between Calls
If two calls are in progress (one active and one on hold),
push the Phone button until you hear a single beep,
indicating that the active and hold status of the two
calls have switched. Only one call can be placed on
hold at a time.
Conference Call
When two calls are in progress (one active and one on
hold):
1. Push and hold the Phone
button until you hear a
double beep, indicating that the two calls have been
joined into one conference call.
Three-Way Calling
To initiate three-way calling, push the Voice Command
button while a call is in progress, and make a
second phone call, as described under “Making a
Second Call While Current Call is in Progress.” After
the second call has established, push and hold the
Phone button until you hear a double beep, indi-
cating that the two calls have been joined into one
conference call.
Call Termination
To end a call in progress:
1. Momentarily push the Phone
button.
• Only the active call(s) will be terminated and if there
is a call on hold, it will become the new active call. If
the active call is terminated by the phone far end, a
call on hold may not become active automatically.
This is cell phone-dependent.
128 UNDERSTANDING THE FEATURES OF YOUR VEHICLE