Gastroback 41400 Design Mincer - Manual (Page 7)

23
Important safeguards for electrical appliances
The appliance is driven electrically. Place the appliance near a suitable wall power socket
to connect the appliance directly to a protected mains power supply with protective conduc-
tor (earth/ground) connected properly. Ensure that the voltage rating of your mains power
supply corresponds to the voltage requirements of the appliance (230 V, 50 Hz, AC, rated
for at least 8 A).
The installation of a residual current operated circuit breaker (r.c.c.b.) with a maximum rated
residual operating current of 30 mA in the supplying electrical circuit is strongly recommen-
ded. If in doubt, contact your electrician for further information.
In various foreign countries, the specifications for power supplies are subject to incompatible
norms. Therefore it is possible that power supplies in foreign countries do not meet the requi-
rements for safe operation of the appliance. Thus, before operating the appliance abroad,
ensure that safe operation is possible.
• Do not to use any extension cords or multi socket outlets.
• Always handle the power cord with care. Always completely unwind the power cord
before use. Do not place the appliance on the power cord. The power cord may never be
knotted, twisted, pulled, strained or squeezed. Do not let the plug or power cord hang over
the edge of the table or counter. The power cord may not touch hot surfaces. Ensure that no
one will pull the appliance by the power cord. Take care not to entangle in the power cord.
Always grasp the plug to disconnect the power cord. Do not touch the power plug with wet
hands when the appliance is connected to the power supply.
• Do not place or immerse the motor housing or the power cord in water or any other liquid.
Do not spill or drip any liquids on the power cord or exterior of the motor housing. When
liquids are spilled on the motor housing or power cord, immediately unplug and switch off
(ON/OFF button) the appliance.
Moving parts – risks of injuries
The mincer is suited for finely chopping food. Thus, moving parts of the appliance can cause
severe injuries, when used contrary to these instructions.
• Do not insert your hands, hair, clothes, brushes, or other foreign objects (e.g. bones,
stalks of vegetables, cooking utensils) in the feed tube of the appliance or in the outlet of the
worm housing, when the appliance is connected to the power supply. Before connecting the
appliance to the power supply, always ensure that there are no foreign objects in the feed
tube or worm housing, and the appliance is assembled completely and correctly. Only use
the provided feedstick to push down the ingredients. Do not push with violence, to avoid that
the mincer gets blocked.
• The edges of the crossed-blade knife are very sharp. Ensure not to get injured when hand-
ling the crossed-blade knife.
• Do not hold your face over the feed tube, while the motor is running, because splinters
could escape from the feed tube, if you failed to see small pieces of bones or other hard
parts (e.g. stalks, hard seeds, stones) while preparing the foods. DO NOT push the foods
with your hands down in the feed tube, or poke in the feed tube!