Gastroback 41400 Design Mincer - Manual (Page 13)

29
Storage
WArNING: Always switch off completely (ON/OFF button), unplug and clean the appli-
ance and all its parts before storing (see: ›Care and Cleaning‹).
Ensure to store the appliance where it is clean, dry and safe from frost, direct sunlight and
inadmissible strain (mechanical or electric shock, heat, moisture) and where it is out of reach
of young children. Place the appliance on a clean and stable surface, where it can not fall.
Do not place any hard or heavy objects on the appliance or any part of it.
Always handle the power cord with care. Power cords may never be knotted, twisted,
pulled, strained or squeezed.
Do not use any parts or tools of the appliance for any other purpose than operating the
appliance. It is a good advice to store the parts and accessories of the appliance with the
appliance.
1. Always clean the appliance and its parts before storage (see: ›Care and Cleaning‹).
2. It is good advice to re-assemble the worm housing with worm and a grinding disc before
storage, (see: ›Assembling the appliance‹) to avoid injuries by the crossed-blade knife.
3. Carefully roll up the power cord without knotting or bending it.
cAUTION: Do not carry the appliance by the food pan or cutter housing. To move the
motor housing, always grasp it at both sides near the bottom.
4. Grasp the motor housing with both hands at its sides, and place it and all parts and tools
on a suitable surface, where it can not fall, and is out of reach of young children.
Troubleshooting
Possible problem Easy solution
The mince is not fine enough. Use a smaller grinding disc and/or mince the ingre-
dients more then once.
There are still ingredients in the
feed tube but no mince is coming
out of the mincer.
The mincer is blocked. Turn the appliance off immedi-
ately and operate according to the instructions ›Clear
a blocking‹.
The motor stops running while
operating.
The overload protection might got activated. Turn
the appliance off immediately and operate according
to the instructions ›Clear a blocking‹.
After cleaning the motor does not get
started again when turning the appli-
ance on.
• Is the power cord plugged in?
• The motor might be blocked with some hard sub-
stance (for example a bone). Turn the appliance
off immediately and pull the plug.
• Disassemble and clean the appliance. Operate
according to the instructions ›Care and cleaning‹.
• If the problem is not solved after the cleaning,
take the appliance for technical maintenance and
repair to an authorised service centre.